Special UV adhesive supply electronic scales 

 Applications 

 Professional Electronic Scale used in glass industry, metal base and the adhesive, especially for stainless steel, aluminum, plating alloy structural bonding material. 

 Features 

 1, glass, flexible metal stick, high and low temperature enhanced formula, typically used for electronic scale industries. Especially for the European market requirements for low temperature has special electronic scale. 

 2, metal and plating on a variety of effective, compared to the general toughness of UV glue significantly higher and sustained impact of blows, the deformation of aluminum can bend, can be anti-high-frequency vibration. 

 3, flexibility, enhanced formula, with excess adhesive after curing can be easily cleaned. Especially in the high temperature thermal environment remains stable. 

 4, clear plastic than the average have higher UV transparency, good weatherability, long-cured products, the same yellow, not albino. 



 Technical parameters 


 Performance 

 Conditions / unit 

 Index value 

 Appearance 

 Visual 

 Transparent liquid 

 Viscosity 

 25 ℃ / 

 1100 

 Index of refraction 

 % 

 1.479 

 Density 

 g/cm3 

 1.01 

 Positioning time 

 120W / S 

 12 

 1000W / S 

 6 

 Full curing time 

 1000W / S 

 45 

 Tensile strength 

 mpa 

 29 

 Shear strength 

 mpa 

 24 

 Peel strength 

 kgf/cm2 

 2.33 

 Hardness 

 HD 

 65 

 Fracture extension rate 

 % 

 270 

 Experimentation 

 Destructive test 

 Aluminum handle / glass 

 Material damage 

 Aging test 

 Water / 72h immersion 

 Yet the significant changes in performance parameters 

 -20 ℃ / 480h frozen 

 Boiling water / 24h boiled 

 Temperature cycling test 

 -40 ℃ ~ 120 ℃ / 120h cycles 

 Yet the significant changes in performance parameters 


 Use 

 1, material: first clean the surface to be sticky (free of alcohol, acetone and other clean, be clean and natural evaporation); 

 2, dispensing: turn into the base plate, dispensing equipment will be quantitative (usually the diameter of 3 ~ 5cm, the amount of 0.2 ~ 0.4g) dispensing the center of the base material, pay attention to manual dispensing as far as possible to avoid air bubbles ; 

 3, installed glass: the glass flat and evenly on the base pressure in the air bubbles, compressed by pressure clamp, check the air bubbles. Available paper towels, rags and other clashes Resin; 

 4, UV machine: UV lamp and the illuminated object machine spacing between the 1